LED display screens vary in usage depending on the usage scenes. Commonly used installation methods include column installation, roof installation, wall mounting installation, mosaic installation, seat structure installation, and hanging installation. The applicable scenes are as follows:

1. Column installation: It's suitable for installation in outdoor environments such as parking lots, hospitals, schools and plazas.

2, Roof installation: It's suitable for outdoor advertising, installation site main building roof, the higher the height, the greater the windproof level.

3, Wall mounting installation: mainly installed in the indoor environment of the solid wall.

4, Mosaic installation: suitable for installation in the wall of the solid indoor environment (small area).

5, Seat structure installation: It's to use the concrete structure on the ground to build a wall enough to support the entire LED display, build a steel structure on the wall to install the display.

6, Hanging installation: It's suitable for general outdoor display, such as stations, airports and temporary performances and other large public places.

The suitable installation method is selected, and the operation display is also very important in the later stage. The accurate operation mode is beneficial to the daily maintenance and maintenance of the display. There are mainly the following points of attention.

1. Switching Operation: When turning on the screen: first turn on the computer, then turn on the screen; when turning off the screen: first turn off the screen, then turn off the computer (if you turn off the computer instead of the display screen, it is likely to cause the display to appear bright points, the LED light is burned);

2. The times of switch screens cannot be too frequent, the interval is at least 5min;

3. After the computer enters the control software, it can be powered on;

4. To avoid opening the screen in the case of white screen or out of control, because current of the system is the largest in this situation, it's easy to cause short circuit;

5, When the ambient temperature is too high or the heat is not good, be careful not to open the screen for a long time;

6. When a part of the electronic display body appears very bright, pay attention to closing the screen in time, and it is not suitable to open the screen for a long time in this state;

7. If the power of the display often trips, it is necessary to check the screen or replace the power switch in time;

8. Regularly check the solid condition of the hook. If there is looseness, pay attention to timely adjustment and re-reinforcement;

9. According to the environment of the display screen and the control part, place the pest control medicine;

10. If the power distribution is large, you can add a power segment controller.

Focono Optoelectronics reminds you that you must pay attention to safety when installing and using LED displays, also in other cases.